Technical components made of glass fibre-reinforced high-temperature plastics to replace metal. These components are found in the bathroom / sanitary area behind plaster or in the fittings. A particular requirement is to guarantee high pressure flow rates and the permanent alternation of cold and hot water. The strict tolerances of the injection moulded components are based on the dimensions of metal components. This is why the design of the cooling circuits, the tool concept and the equipment used during production are key to the quality of the final product ready for series production.
A medium-sized industrial manufacturing company for injection-moulded plastic components with aesthetic and technical requirements.
GERDES Kunststoff-Technik GmbH
Breslauer Straße 2a
32699 Extertal
Germany
Management:
Sandro Betke,
Norman Weigand
Contact person:
Sebastian Haake
Employees:
260
Foundation:
1873
E²MS full-service partner for the production of electronic assemblies, modules and devices
PRETTL Electronics GmbH
Robert-Bosch-Straße 10
01454 Radeberg
Germany
Management:
Carsten Ellermeier, Miroslaw Dziuba
Employees:
550
Foundation:
2000